Lên đến 28 dBm truyền tải điện năng cho phép kết nối tầm xa
Hỗ trợ IEEE 802.11a / b / g / n tiêu chuẩn không dây lên đến 450 Mbps tốc độ dữ liệu trên mỗi băng
Sáu ăng-ten MIMO 5 dBi omni-directional nội
Có thể được sử dụng với bộ chuyển đổi điện đi kèm hoặc qua PoE với PoE 802.3at – switch có khả năng hoặc phun
SSID-to-VLAN Tagging
Lý tưởng cho chuyển file, VoIP, streaming video, âm nhạc, và các ứng dụng đa phương tiện khác
Đồng thời băng tần kép lên đến 450 Mbps trên cả 2,4 và 5 dải tần số GHz cho hiệu suất thông không dây tối đa.
High Power, Long-Range và Nhiều Tầng Penetration
Lên đến 28 dBm cho RF truyền (Tx) điện với ăng-ten 5dBi 6x nội bộ cho cả hai băng tần 5GHz 2.4GH và cung cấp phủ sóng Wi-Fi nhiều hơn gấp đôi phạm vi hơn đối thủ cạnh tranh chính cho phép các tín hiệu không dây để thâm nhập vào sàn nhà, trần nhà và tường cho lớn kết nối thiết bị.
Technical Specifications
Hardware
RF: 2.4 and 5 GHz Frequency Bands
Standard: IEEE 802.11a/b/g/n
Radio I: 11b/g/n: 2.412~2.484 GHz
Radio II: 11a/n: 5.18-5.24 and 5.26-5.32 and 5.5-5.7 and 5.745-5.825 GHz
Data Rate: Up to 450 Mbps in both frequency bands
Memory: 64MB
Flash Memory: 8MB
Power Consumption: Up to 22W
Antenna
Six (6) Internal 5 dBi Omni-Directional Antennas
Physical Interface
1 x RJ-45 Gigabit Ethernet (10/100/1000 Mbps)
1 x Reset Button
1 x Power Connector
Power Requirements
Power Supply: 90 to 240 VDC ± 10%, 50/60 Hz
(depends on different countries)
Active Ethernet (Power-over-Ethernet, IEEE 802.3at)
Power Adapter (United States) 48VDC/0.375A
Device: 12V/2A
Modulations
OFDM: BPSK, QPSK, 26-OAM, 64-QAM, DBPSK, DQPSK, CCK
Operating Channels
2.4 GHz: US/Canada 1-11
5 GHz: Country dependent for the following ranges:
36, 40, 44, 48, 52, 56, 60, 64, 100, 104, 108, 112, 116, 120, 124, 128, 132, 136, 140, 149, 153, 157, 161, 165
Software
Topology
Infrastructure/Ad-Hoc
Operation Modes
Access Point, WDS Bridge, WDS Access Point
Multiple BSSID
Supports up to 8 BSSIDs per radio
LAN
IP (check validity and DHCP server IP range) MAC
SSID-to-VLAN Tagging
Supports 802.1q SSID-to-VLAN tagging
Spanning Tree
Supports 802.1d Spanning Tree Protocol
Wireless
Wireless Mode: 11a/11b/11g/11n
Channel selection (settings vary by country)
Channel bandwidth (Auto, 20 MHz, 40 MHz)
Transmission rate:
2.4 GHz: 11n only, 11b/b/n mix, 11b only, 11b/g, 11g only
5 GHz: 11n only, 11a/n mix, 11a only
QoS
WMM (Wireless Multimedia)
VPN
Pass-through (PPTP, L2TP, IPSec)
WPS
Software only
Management
Tx Power Control
Adjust transmit power by dBm
Configuration
Web-based configuration (http)/Telnet
Telnet Server
CLI
Firmware Upgrade
Via web browser, settings are reserved after upgrade
Administrator Setting
Administrator Username and Password Change
Reset Setting
Reboot (press 1 second).
Reset to factory default (press 10 seconds)
System Monitoring
Status Statistic and Event Log
SNMP
V1, V2c, V3
MIB
MIB I, MIB II (RFC1213) and private MIB
Traffic Shaping
Incoming and outgoing wireless traffic shaping
Auto-channel Selection
Automatically selecting least congested channel
Bandwidth Measurement
IP range and bandwidth management
Auto Reboot
Reboot Access Point by minute, hour, day, or week
Backup and Restore
Save and restore settings through Web interface
CLI
Supports Command Line Interface
Diagnosis
IP pinging statistics
Log
SysLog and Local Log support
LED Control
On/Off
AP Detection
Scanning for available EnGenius APs
Wireless / Network
PPPoE: Point-to-Point Protocol over Ethernet in Client Router mode
(this function will keep trying when failed or disconnected)
PPTP: Point-to-Point Tunneling Protocol (PPTP) is a method for implementing virtual private networks
Wireless Security
WPA/WPA2 Personal (WPA-PSK using TKIP or AES)
WPA/WPA2 Enterprise (WPA-EAP using TKIP)
802.1X RADIUS Authenticator: MD5/TLS/TTLS, PEAP
SSID broadcast enable/disable
MAC Address Filtering, Up to 50 fields
L2 Isolation (Access Point mode)
Wireless STA (Client) connected list (Idle/Connection Time, Pkt statistics)
QoS (Quality of Service)
WMM (Wireless Multimedia)
Environmental & Physical
Temperature Range
Operating: 0ºC to 50ºC (32ºF to 122ºF)
Storage: -20ºC to 60ºC (-4Fº to 140ºF)
Humidity (non-condensing)
Operating: 90% or less
Storage: 90% or less
Certifications
FCC, IC
Maximum data rates are based on IEEE 802.11 standards. Actual throughput and range may vary depending on many factors including environmental conditions, distance between devices, radio interference in the operating environment, and mix of devices in the network. Features and specifications subject to change without notice. Trademarks and registered trademarks are the property of their respective owners. For United States of America: Copyright ©2014 EnGenius Technologies, Inc. All rights reserved. Compliant with FCC – This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his/her own expense.
Dimensions & Weights
EAP900H Device
Weight: 0.62 lbs.
Diameter: 6.36”
Height: 1.64”
Package Contents
EAP900H Dual Band N900 Indoor Access Point
12V/2A Power Adapter
T-Rail Mounting Kit
Ceiling Mount and Wall Screw Kit
Mounting Bracket
RJ-45 Ethernet Cable
Quick Installation Guide
Warranty
1 Year
Đánh giá
Chưa có đánh giá nào.